Pico Technology TA112 Oscilloscope Probe, Active Type, 1 GHz, 10:1, BNC Connector

This oscilloscope probe is an Active measurement accessory designed for precision signal acquisition with high-frequency instruments. It connects via a BNC Interface and attenuates signals to facilitate safer and clearer measurements on high-bandwidth scopes. The probe meets multiple industry standards and is intended for laboratory, development and field-test environments where accurate representation of signals up to gigahertz frequencies is required.

• 1GHz bandwidth provides fast signal fidelity for high-frequency work
• 10:1 attenuation reduces input amplitude for scope protection
• BNC connector ensures secure electrical connection to instruments
• Active probe design maintains signal integrity at high speeds
• Low-capacitance topology supports minimal loading on measured circuits

• Suitable for circuit debug on RF and high-speed digital boards
• Used with oscilloscopes requiring reduced input amplitude
• Ideal for validation of high-bandwidth analogue signals
• Can be used for component characterisation in test benches
• Used for lab-based waveform capture during development

It uses a BNC connector for direct attachment to compatible instruments.

The 10:1 attenuation lowers measured voltage by a factor of ten allowing higher input voltages to be observed safely while reducing the load presented to the circuit.

The probe is specified to operate up to 1GHz which defines the upper frequency at which intended signal fidelity is maintained.

It employs an Active probe architecture that provides buffering and lower input loading compared with passive types.

It is produced in accordance with multiple standards including EN 61010 and EN 61326 and conforms to RoHS and WEEE environmental requirements.

Power supply