Ultimaker Nozzle Nozzle for use with Ultimaker 2, Olsson Block 0.5 mm

ดู 3D Printer Parts ทั้งหมด
ไม่พร้อมจำหน่ายในตอนนี้
เราไม่ทราบว่าสินค้านี้จะกลับมาในสต็อกหรือไม่ RS ตั้งใจที่จะลบสินค้านี้ออกจากกลุ่มผลิตภัณฑ์ในเร็วๆ นี้
RS Stock No.:
110-1986
หมายเลขชิ้นส่วนของผู้ผลิต / Mfr. Part No.:
OBS001
ผู้ผลิต:
Ultimaker
ค้นหาผลิตภัณฑ์ที่คล้ายกันโดยเลือกคุณลักษณะอย่างน้อยหนึ่งรายการ
เลือกทั้งหมด

Brand

Ultimaker

Product Type

Nozzle

Sub Type

Nozzle

For Use With

Ultimaker 2, Olsson Block

Nozzle Material

Stainless Steel

Nozzle Size

0.5 mm

Standards/Approvals

No

สถานะRoHS: ได้รับการยกเว้น

COO (Country of Origin):
NL

Ultimaker 2 Jet Nozzle - Stainless Steel


The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With this special stainless steel nozzle, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean it efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer

If you print with abbrasive material like Carbon filled filament or Glowfill, this is the nozzle to have! Stainless steel is much stronger, it will wear down much slower than classic brass nozzles which can wear out during one long print! Only thing to remember is to print a little slower because of the difference in conductivity between stainless steel and brass

Ultimaker Accessories


Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

ลิงก์ที่เกี่ยวข้อง