FLUKE-725/9100/RS Drywell Calibrator, 24mA dc, 0 → 30V dc

Drywell Calibration Kits comprising the Fluke 725 process calibrator and 9100S drywell heat source

Two separate channels; measure, source and view process signals simultaneouslyMeasure volts, mA, RTDs, thermocouples, frequency, and resistance to test sensors and transmittersSource/simulate volts, mA, thermocouples, RTDs, frequency, and pressure to calibrate transmittersSource mA with simultaneous pressure measurement to conduct valve and I/P testsPerform fast linearity tests with auto step and auto ramp featuresPower transmitters during test using 24 V loop supply and simultaneous mA measurementStore frequently-used test setups for later use

Contact temperature calibration over a range of –10 °C to 375 °CA stable and uniform heat sourceFast to change temperature to set point with short stabilization timesAccuracy to 0.25°C and stability to 0.07°CMultiple sized sensor holes to accept a wide range of temperature sensor diameters

725 process calibrator, test leads/clips, protective yellow holster; 9100S drywell, batteries, 9100S power Cord, RS-232 Cable, 9930 Interface-it Software.

Fluke 725 Drywell Calibration Kits

The Fluke 725 Drywell Calibration Kits couples the Fluke 725 with a highly portable and compact drywell heat source with a saving over buying the products separately.,The kit offers a rugged, handheld solution for the accurate calibration of temperature sensors and troubleshooting of process control instrumentation.