CEL Single Material Dual Nozzle Head for use with Robox 3D-Printer

The CEL single material dual nozzle head for Robox 3D printer has 2 nozzles both of which are supplied from a single material feed. Silicone heater jackets prevent stray material from sticking to the hot parts of the nozzle and heater block. They also insulate and prevent drafts at the hot end to allow faster heating with less energy.The nozzle head is fitted to Robox via the headlock and system uses needle valves to close the nozzles to avoid stringing and blob.

Note
RBX1 Robox is required to use this kit. Robox is not included and is sold separately. Some simple assembly is required

Detailed high-resolution prints using the smaller 0.3mm nozzle
Fast fill and small details in the same layer of the print
Improved heatsink with more cooling fins and more efficient thermodynamic performance
Material Compatibility: PLA, ABS, HIPS, Nylon, PC, PVA
Modified head housing for improved connection reliability with the x-carriage.
New needle seal design for improved reliability and life.
Quick draft prints using the 0.8mm nozzle
Silicone Thermal Jacket - Improves heat-up time
Titanium Heat Bridge - Fully all-metal construction means the head can cope with higher temperatures (>280°C)